Firmware update
The latest firmware will always be available at www.keene.co.uk./iranywhere.
The current firmware of your module is displayed at the bottom of the “overview” tab on the module's web page.
If the firmware version number is higher on the keene site then download the required file ; either IRAnywhere_receiver.hex or IRAnywhere_target.hex.
Click on the “browse” button to locate the downloaded file. (be patient, it can take a while for the browse wndow to initialise). If the file is correct then the “upload” button will become active. Check again that the target IP address matches that of the module you wish to update and click “upload”. You will see the data transfer message at the bottom of the screen followed by” success” if the operation went smoothly. If you see a “fail” message then check your IP address and firewall settings.
Note - updating the firmware will reset everything on the module to the factory default settings. The IP will revert to 192.168.1.31 (for the target) and 192.168.1.32 (for the receiver). DHCP will be initialised and any IR codes stored within the modules will also need to be uploaded again.
Note - usually when you click the button to upload the file the amber ACK light on the unit will come on. This indicates that the module has been put into re-boot by the software.
If this doesn't happen then one short press of the reset button will reboot the module and allow communication with the upload software.