Marmitek IR Control 10 IR Extender Kit
Operate any of your A/V equipment which is located behind closed cupboard doors (or even from another room) with your current remote control.
With the IR Control 10 you can operate 4 pieces of equipment.
With the exception of the very small IR receiver, the complete set can be located completely out of sight.
Works with almost all brands and models and is also suitable for new IR code formats (such as RC-MM) which are used in many new HD devices and digital TV decoders.
Incorporates new IR filter techniques for use in the vicinity of Flat Screen TVs (Plasma, LCD and LED), indirect sunlight and energy-efficient light bulbs.
Compatible with all digital TV providers in Europe, like BT Vision, Freesat, Freeview, Sky TV, Sky+, Sky HD and Virgin.
How does the IR Control 10 work?
Locate your A/V equipment in a closed cupboard, TV cabinet or even in another room. The IR receiver must be installed in view of your own remote control. This new, updated IR receiver can even be placed in the vicinity of your Flat Screen (Plasma, LCD or LED screen). Point the remote control at the IR receiver in
order to send the appropriate command to the IR LEDs (via the IR main module). These will then immediately pass this onto the A/V equipment.
1 x IR Main Hub
1 x IR Receiver
2 x IR Extension cable with two IR emitter LEDs
1 x Power adaptor
1 x Manual
Frequency range: 30-60 KHz
IR reception range: +/- 10 metres
IR reception angle: 90 (+45/-45 from centre)
Cable length: 3 metres, extendable up to 300 metres
IR reception indication: YES, purple indication LED
Status indication: YES, green indication LED
Receiver dimensions: 40 x 13 x 11mm
Power supply POWER: 100-240VAC 50/60Hz, 12VDC 200mA (supplied)
Power supply STATUS: 5-24VDC / 5-12VAC plug, - 5.5mm outside / +
2.1mm inside (not supplied)
IR input: 1x 3.5mm jack connector, for standard IR receiver
1x screw connector, for up to 6 in parallel
connected IR receivers. Extendable up to 300
metres using CAT5 (or equivalent)
IR output: 4x 3.5mm jack plug (mono), switchable for IR
extension cables with emitter or blaster LEDs
Dimensions: 95 x 46 x 20mm
IR extension cable with 2 emitter LEDs
Connection: 3.5mm jack plug (mono)
IR LEDs: 2x IR emitter LEDs
Cable length: 3 metres
|Info||Operate any of your A/V equipment which is located behind closed cupboard doors|
|•||With IR blaster function for operating numerous devices with one IR blaster|
|•||Works with almost all brands and models and is also suitable for new IR code formats|
|•||Incorporates new IR filter techniques for use in the vicinity of Flat Screen TVs|
1) Data Sheet (PDF)